P21B5 — NOx adsorber over-temperature, bank 2
| Meaning | The control unit detected too high a temperature in the NOx adsorber on bank 2, the side of the engine that does not contain cylinder 1. The part traps nitrogen oxides and strong overheating can ruin it. The exact way this is detected depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or limp mode
Burning smell from the exhaust
Higher fuel consumption than usual
More frequent regeneration cycles
Worse emissions if tested
Common causes
Too much fuel injected during exhaust cleaning
Faulty bank 2 exhaust temperature sensor
Faulty injector on a bank 2 cylinder
Clogged catalytic converter or filter upstream
NOx adsorber already degraded
What to do
How to read code P21B5
This is a critical fault: vehicle safety or integrity may be compromised, so diagnosis should not be postponed.
The code P21B5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21B5 mean?
NOx adsorber over-temperature, bank 2. The control unit detected too high a temperature in the NOx adsorber on bank 2, the side of the engine that does not contain cylinder 1. The part traps nitrogen oxides and strong overheating can ruin it. The exact way this is detected depends on the manufacturer.
Can I keep driving with code P21B5 active?
With caution: limp mode possible, have it checked soon
Common causes — P21B5
Regeneration cycles that run too long or too often on bank 2 Too much fuel injected during exhaust cleaning Faulty bank 2 exhaust temperature sensor Faulty injector on a bank 2 cylinder Clogged catalytic converter or filter upstream NOx adsorber already degraded
How do you fix code P21B5?
Have the bank 2 temperature data checked and compared with bank 1. If they differ a lot, the problem is probably only on that side. Avoid prolonged hard driving until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21B4 — NOx adsorber over-temperature
- Next code: P21B6 — Cold start injection timing, cylinder 1
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance