P21B8 — Cold start injection timing, cylinder 3
| Meaning | The control unit detected a problem with the injection timing of cylinder 3 during a cold start. The exact meaning of this code is defined by the manufacturer and I don't have reliable information for every make. In general it means injection in that cylinder is not within expected values when the engine is cold. |
| Family | Powertrain (P) |
Typical symptoms
Rough running in the first minutes
Unusual smoke from the exhaust when cold
Check engine light on
Vibration or knocking when cold
Common causes
Wiring or connector problem at the injector
Engine temperature sensor giving wrong readings
Incorrect fuel pressure
Timing or synchronization problem
ECU software needing an update
What to do
How to read code P21B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21B8 mean?
Cold start injection timing, cylinder 3. The control unit detected a problem with the injection timing of cylinder 3 during a cold start. The exact meaning of this code is defined by the manufacturer and I don't have reliable information for every make. In general it means injection in that cylinder is not within expected values when the engine is cold.
Can I keep driving with code P21B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P21B8
Faulty or dirty cylinder 3 injector Wiring or connector problem at the injector Engine temperature sensor giving wrong readings Incorrect fuel pressure Timing or synchronization problem ECU software needing an update
How do you fix code P21B8?
Have the cold-start injection data read and the cylinder 3 injector and connectors checked. You can drive carefully for short trips, but if the engine runs badly or shakes a lot, stop and have it checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21B7 — Cold start injection timing, cylinder 2
- Next code: P21B9 — Cold start injection timing, cylinder 4
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance