P21C2 — Reductant heater relay circuit open
| Meaning | The control unit detected an open circuit in the control of the relay that powers the reductant heater. The reductant is the AdBlue fluid used to cut nitrogen oxides. Without this heating the fluid can stay frozen in cold weather. How exactly the system detects it varies by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Message about an emissions system fault
Starting problems after the system imposes a lockout
Fluid does not thaw in cold weather
Power limitation on some vehicles
Common causes
Faulty relay
Broken wire or corroded connector
Faulty tank heater
Faulty output in the AdBlue system control unit
What to do
How to read code P21C2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21C2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (C2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21C2 mean?
Reductant heater relay circuit open. The control unit detected an open circuit in the control of the relay that powers the reductant heater. The reductant is the AdBlue fluid used to cut nitrogen oxides. Without this heating the fluid can stay frozen in cold weather. How exactly the system detects it varies by manufacturer.
Can I keep driving with code P21C2 active?
With caution: limp mode possible, have it checked soon
Common causes — P21C2
Blown relay fuse Faulty relay Broken wire or corroded connector Faulty tank heater Faulty output in the AdBlue system control unit
How do you fix code P21C2?
Have the fuse, relay and connectors checked first, as they are the simplest to verify. Don't ignore the code: on many cars, if the AdBlue system isn't working, the engine may refuse to restart after a certain distance.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21C1 — Cold start injection timing, cylinder 12
- Next code: P21C3 — Reductant heater relay control circuit low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance