P21CA — AdBlue control module supply voltage circuit fault
| Meaning | The control unit found a problem in the circuit that carries supply voltage to the reductant (AdBlue) control module. The code doesn't say whether the voltage is too high or too low, only that the circuit is not normal. Without correct power the module may not work properly. |
| Family | Powertrain (P) |
Typical symptoms
Dashboard message about AdBlue or emissions
No or intermittent AdBlue dosing
Problem that comes and goes
Possible power reduction
Common causes
Damaged power supply wiring
Fuse or relay problem
Poor ground connection
Weak battery or irregular charging system
Faulty control module
What to do
How to read code P21CA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P21CA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (1) points to fuel and air metering, and the last two (CA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P21CA mean?
AdBlue control module supply voltage circuit fault. The control unit found a problem in the circuit that carries supply voltage to the reductant (AdBlue) control module. The code doesn't say whether the voltage is too high or too low, only that the circuit is not normal. Without correct power the module may not work properly.
Can I keep driving with code P21CA active?
With caution: limp mode possible, have it checked soon
Common causes — P21CA
Corroded connector or loose contacts at the module Damaged power supply wiring Fuse or relay problem Poor ground connection Weak battery or irregular charging system Faulty control module
How do you fix code P21CA?
First check the battery, fuses and the connectors of the module's power supply. Also check the ground points, which are a common cause of intermittent faults. Don't leave the car like this for too long, as the SCR system could trigger restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P21C9 — AdBlue module power relay: control circuit high
- Next code: P21CB — AdBlue control module supply voltage too low
Related codes
- P2100 — Throttle actuator motor circuit open
- P2101 — Throttle actuator motor circuit range/performance
- P2102 — Throttle actuator motor circuit low
- P2103 — Throttle actuator motor circuit high
- P2104 — Throttle actuator control system forced idle
- P2105 — Throttle actuator control system forced engine shutdown
- P2106 — Throttle actuator control system forced limited power
- P2107 — Throttle actuator control module processor fault
- P2108 — Throttle actuator control module performance
- P2109 — Throttle/pedal sensor A minimum stop performance
- P210A — Starter lockout relay K38/3: short circuit or open wiring
- P210B — Throttle actuator B control motor circuit range/performance