P2218 — NOx sensor heater control circuit open (bank 2)
| Meaning | The control unit has detected that the circuit driving the heater inside the bank 2 NOx sensor is open, meaning no current flows. The heater brings the sensor up to working temperature, and without it the sensor cannot read nitrogen oxides in the exhaust correctly. The exhaust aftertreatment system may therefore lose control of emissions. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system fault message
Reduced power on some vehicles
Abnormal AdBlue use or dosing switched off
Failing the emissions inspection
Common causes
Broken or heat-damaged heater wire
Faulty NOx sensor with a burnt-out internal heater
Faulty NOx sensor control module
Missing fuse or power supply to the sensor
What to do
How to read code P2218
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2218 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (18) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2218 mean?
NOx sensor heater control circuit open (bank 2). The control unit has detected that the circuit driving the heater inside the bank 2 NOx sensor is open, meaning no current flows. The heater brings the sensor up to working temperature, and without it the sensor cannot read nitrogen oxides in the exhaust correctly. The exhaust aftertreatment system may therefore lose control of emissions.
Can I keep driving with code P2218 active?
With caution: limp mode possible, have it checked soon
Common causes — P2218
Corroded or poorly seated NOx sensor connector Broken or heat-damaged heater wire Faulty NOx sensor with a burnt-out internal heater Faulty NOx sensor control module Missing fuse or power supply to the sensor
How do you fix code P2218?
First check the connector and wiring of the bank 2 NOx sensor, looking for burnt or pinched wires and signs of moisture. If the wiring is sound, an electrical test on the sensor is needed to tell whether the sensor itself has failed. Don't leave it too long: on many vehicles the system can cut power or prevent a restart if the fault persists.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2217 — NOx sensor intermittent signal, bank 2
- Next code: P2219 — NOx sensor heater control circuit low (bank 2)
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3