P222F — Barometric pressure sensors A and B disagree
| Meaning | The control unit compares the two atmospheric pressure sensors (A and B) and found their readings differ by more than allowed. At least one of them is measuring wrongly, but the code alone does not say which. The layout of the two sensors depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power, especially at altitude or uphill
Rough idle
Reduced engine performance in some cases
Starting that feels less crisp than usual
Common causes
Blocked air port or duct leading to a sensor
Damaged wiring or connector on one of the sensors
Restriction in the air filter or intake duct
Internal control unit fault (uncommon)
What to do
How to read code P222F
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P222F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (2F) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P222F mean?
Barometric pressure sensors A and B disagree. The control unit compares the two atmospheric pressure sensors (A and B) and found their readings differ by more than allowed. At least one of them is measuring wrongly, but the code alone does not say which. The layout of the two sensors depends on the manufacturer.
Can I keep driving with code P222F active?
With caution: limp mode possible, have it checked soon
Common causes — P222F
One of the two barometric sensors is faulty Blocked air port or duct leading to a sensor Damaged wiring or connector on one of the sensors Restriction in the air filter or intake duct Internal control unit fault (uncommon)
How do you fix code P222F?
Have both sensor values read with the engine off: they should be almost the same. Then check the one that is off, starting with its connector, wiring and ducts.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P222E — Barometric pressure sensor B: erratic signal
- Next code: P2230 — Barometric pressure sensor circuit intermittent
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3