P2238 — O2 sensor bank 1 sensor 1: positive current control too low
| Meaning | The control unit found a value that is too low in the positive current control circuit of the upstream wideband oxygen sensor on bank 1. The sensor is not working as it should and the mixture reading is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Power loss
Fuel use that seems higher
Smoke or smell of an incorrect mixture
Common causes
Connector with corrosion or water
Faulty oxygen sensor
Pinched or burnt wiring
Control unit circuit fault (uncommon)
What to do
How to read code P2238
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2238 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (38) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2238 mean?
O2 sensor bank 1 sensor 1: positive current control too low. The control unit found a value that is too low in the positive current control circuit of the upstream wideband oxygen sensor on bank 1. The sensor is not working as it should and the mixture reading is not reliable.
Can I keep driving with code P2238 active?
With caution: limp mode possible, have it checked soon
Common causes — P2238
Wire shorted to ground Connector with corrosion or water Faulty oxygen sensor Pinched or burnt wiring Control unit circuit fault (uncommon)
How do you fix code P2238?
Check the wiring and connector of the upstream sensor, looking for shorts to ground or damaged insulation. It is better not to keep driving for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2237 — O2 sensor bank 1 sensor 1: positive current contro...
- Next code: P2239 — O2 sensor bank 1 sensor 1: positive current contro...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3