P2245 — O2 sensor bank 1 sensor 1: reference voltage circuit low
| Meaning | The engine computer measured too low a reference voltage in the circuit of the upstream oxygen sensor on bank 1. This generally indicates a short to ground in the wiring or a faulty sensor. The mixture reading becomes unreliable. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Jerking or hesitation when accelerating
Increased fuel consumption
Reduced performance
Common causes
Wet, corroded or damaged connector
Faulty wide-band oxygen sensor
Wiring pinched or burnt near the exhaust
Rarely, an internal fault in the engine computer
What to do
How to read code P2245
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2245 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (45) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2245 mean?
O2 sensor bank 1 sensor 1: reference voltage circuit low. The engine computer measured too low a reference voltage in the circuit of the upstream oxygen sensor on bank 1. This generally indicates a short to ground in the wiring or a faulty sensor. The mixture reading becomes unreliable.
Can I keep driving with code P2245 active?
With caution: limp mode possible, have it checked soon
Common causes — P2245
Sensor wire with worn insulation touching ground Wet, corroded or damaged connector Faulty wide-band oxygen sensor Wiring pinched or burnt near the exhaust Rarely, an internal fault in the engine computer
How do you fix code P2245?
First look at the wiring of the bank 1 upstream sensor near the exhaust and at the connector, looking for burnt insulation or pinched wires. If nothing turns up, electrical measurements are needed. Better not to delay for long, because the mixture is not being regulated correctly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2244 — O2 sensor bank 1 sensor 1: reference voltage out o...
- Next code: P2246 — O2 sensor bank 1 sensor 1: reference voltage circu...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3