Skip to content
Fault code dictionary (DTC)

P224E — Alternative fuel tank shutoff valve A: control circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer measured too low a signal in the control circuit of valve A of the alternative fuel tank, for example LPG or CNG. This usually indicates a short to ground in the wiring or an electrical problem in the valve. The code is a SAE standard, but exact operation depends on the installed system.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Engine does not switch to the alternative fuel
Running on petrol only
Stalling or lack of power on gas
Possible blown fuse

Common causes

Control wire shorted to ground
Shorted valve coil
Wet, corroded or damaged connector
Wiring pinched or with damaged insulation
Rarely, a driver fault in the control unit

What to do

Check the fuse, connector and wiring of the valve, looking for pinched wires or damaged insulation. If the fuse blows again, do not replace it with a higher-rated one. Have the system checked by a workshop qualified in gas systems.

How to read code P224E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P224E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (4E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P224E mean?

Alternative fuel tank shutoff valve A: control circuit low. The engine computer measured too low a signal in the control circuit of valve A of the alternative fuel tank, for example LPG or CNG. This usually indicates a short to ground in the wiring or an electrical problem in the valve. The code is a SAE standard, but exact operation depends on the installed system.

Can I keep driving with code P224E active?

With caution: limp mode possible, have it checked soon

Common causes — P224E

Control wire shorted to ground Shorted valve coil Wet, corroded or damaged connector Wiring pinched or with damaged insulation Rarely, a driver fault in the control unit

How do you fix code P224E?

Check the fuse, connector and wiring of the valve, looking for pinched wires or damaged insulation. If the fuse blows again, do not replace it with a higher-rated one. Have the system checked by a workshop qualified in gas systems.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes