Skip to content
Fault code dictionary (DTC)

P2250 — O2 sensor bank 2 sensor 1: reference voltage circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected too high a reference voltage in the circuit of the upstream oxygen sensor on bank 2. It may be caused by contact with a power wire or by a faulty sensor. The computer therefore cannot read the mixture on that bank well.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough idle
Loss of power
Higher fuel consumption
Hard starting or occasional stalling

Common causes

Sensor wire touching a power cable
Corroded or damaged connector, or bent pins
Faulty wide-band oxygen sensor
Wiring damaged by heat or rubbing
Rarely, a fault in the engine computer

What to do

Check the connector and wiring of the bank 2 upstream sensor, looking for bare wires or wires in contact with other cables. If the wiring is intact, the sensor is the main suspect. Deal with it within a reasonable time to avoid wrong mixture regulation.

How to read code P2250

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2250 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (50) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2250 mean?

O2 sensor bank 2 sensor 1: reference voltage circuit high. The engine computer detected too high a reference voltage in the circuit of the upstream oxygen sensor on bank 2. It may be caused by contact with a power wire or by a faulty sensor. The computer therefore cannot read the mixture on that bank well.

Can I keep driving with code P2250 active?

With caution: limp mode possible, have it checked soon

Common causes — P2250

Sensor wire touching a power cable Corroded or damaged connector, or bent pins Faulty wide-band oxygen sensor Wiring damaged by heat or rubbing Rarely, a fault in the engine computer

How do you fix code P2250?

Check the connector and wiring of the bank 2 upstream sensor, looking for bare wires or wires in contact with other cables. If the wiring is intact, the sensor is the main suspect. Deal with it within a reasonable time to avoid wrong mixture regulation.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes