P2255 — Bank 2 sensor 1 O2 sensor: pumping current circuit low
| Meaning | The engine computer measured a lower than expected voltage in the pumping current circuit of the wide-band oxygen sensor before the catalytic converter on bank 2. This usually points to a short to ground or an electrical fault in the sensor. The computer is therefore missing important information for metering fuel. |
| Family | Powertrain (P) |
Typical symptoms
Unstable idle
Increased fuel consumption
Lack of power when accelerating
Engine going into limp mode
Black smoke or smell of unburned fuel
Common causes
Corroded sensor connector or water inside it
Faulty bank 2 upstream oxygen sensor
Wiring crushed or burnt near the exhaust
Faulty engine computer (rare)
What to do
How to read code P2255
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2255 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (55) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2255 mean?
Bank 2 sensor 1 O2 sensor: pumping current circuit low. The engine computer measured a lower than expected voltage in the pumping current circuit of the wide-band oxygen sensor before the catalytic converter on bank 2. This usually points to a short to ground or an electrical fault in the sensor. The computer is therefore missing important information for metering fuel.
Can I keep driving with code P2255 active?
With caution: limp mode possible, have it checked soon
Common causes — P2255
Sensor wire touching ground due to damaged insulation Corroded sensor connector or water inside it Faulty bank 2 upstream oxygen sensor Wiring crushed or burnt near the exhaust Faulty engine computer (rare)
How do you fix code P2255?
Inspect the bank 2 sensor wiring along its whole path, especially where it passes near manifolds and hot parts or where it can rub. Check the connector as well. Drive carefully and have the car checked soon, because the mixture is not being controlled properly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2254 — Bank 2 sensor 1 O2 sensor: pumping current circuit...
- Next code: P2256 — Bank 2 sensor 1 O2 sensor: pumping current circuit...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3