P225A — NOx sensor bank 1 sensor 1: calibration memory error
| Meaning | The NOx sensor measures nitrogen oxides in the exhaust gas and contains a memory with its calibration data. The engine computer found an error in this data on bank 1, sensor 1, which is usually the one upstream of the treatment system. Without valid calibration the reading is not reliable. The exact meaning can vary a little between manufacturers. |
| Family | Powertrain (P) |
Typical symptoms
Emission system fault message
Abnormal AdBlue consumption
Possible power limitation
Possible restricted start warning
No obvious symptoms in some cases
Common causes
Replaced sensor not matched or coded to the computer
Damaged sensor connector or wiring
Faulty NOx sensor control unit
Engine computer software needing an update
What to do
How to read code P225A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P225A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (5A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P225A mean?
NOx sensor bank 1 sensor 1: calibration memory error. The NOx sensor measures nitrogen oxides in the exhaust gas and contains a memory with its calibration data. The engine computer found an error in this data on bank 1, sensor 1, which is usually the one upstream of the treatment system. Without valid calibration the reading is not reliable. The exact meaning can vary a little between manufacturers.
Can I keep driving with code P225A active?
With caution: limp mode possible, have it checked soon
Common causes — P225A
Faulty NOx sensor or damaged memory Replaced sensor not matched or coded to the computer Damaged sensor connector or wiring Faulty NOx sensor control unit Engine computer software needing an update
How do you fix code P225A?
Have the sensor data read with a suitable diagnostic tool and check the connector and wiring. If the sensor was replaced recently, make sure it is the correct one and that it was properly enabled. Don't ignore it: with the emission system faulty some cars limit engine power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2259 — Secondary air injection: control circuit B low
- Next code: P225B — NOx sensor bank 1 sensor 2: calibration memory err...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3