P225E — NOx sensor bank 1 sensor 2: signal biased or stuck high
| Meaning | The engine computer compared the reading of the downstream NOx sensor on bank 1 with the expected one and found it too high or stuck at a fixed value. This sensor is used to check whether the treatment system is working. The fault may be in the sensor or in the treatment system itself. |
| Family | Powertrain (P) |
Typical symptoms
Emission system fault message
Higher than normal AdBlue consumption
Possible power limitation
Higher emissions
No obvious symptoms in some cases
Common causes
Incorrect AdBlue level or quality
Aged or faulty downstream NOx sensor
Exhaust leaks near the sensor
Damaged wiring or connector
What to do
How to read code P225E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P225E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (5E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P225E mean?
NOx sensor bank 1 sensor 2: signal biased or stuck high. The engine computer compared the reading of the downstream NOx sensor on bank 1 with the expected one and found it too high or stuck at a fixed value. This sensor is used to check whether the treatment system is working. The fault may be in the sensor or in the treatment system itself.
Can I keep driving with code P225E active?
With caution: limp mode possible, have it checked soon
Common causes — P225E
Inefficient NOx treatment system (SCR) Incorrect AdBlue level or quality Aged or faulty downstream NOx sensor Exhaust leaks near the sensor Damaged wiring or connector
How do you fix code P225E?
First check the AdBlue level and quality, then have the sensor data read and make sure there are no exhaust leaks. Don't wait, as the emission system may limit power or prevent restarting.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P225D — NOx sensor bank 1 sensor 1: signal biased or stuck...
- Next code: P225F — NOx sensor bank 1 sensor 2: signal biased or stuck...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3