P2260 — Secondary air injection: control circuit B high
| Meaning | The engine computer controls the system that blows fresh air into the exhaust on a cold engine. In control circuit B it detected a voltage that is too high, meaning the control is not behaving as it should. Which part is on circuit B depends on the make and model. |
| Family | Powertrain (P) |
Typical symptoms
Air pump or valve staying active when it shouldn't
Higher emissions after a cold start
Possible emissions test problem
Usually normal driving
Common causes
Control wire touching a power supply
Corroded or damaged connector
Pump or valve with an electrical fault
Faulty engine computer (rare)
What to do
How to read code P2260
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2260 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (60) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2260 mean?
Secondary air injection: control circuit B high. The engine computer controls the system that blows fresh air into the exhaust on a cold engine. In control circuit B it detected a voltage that is too high, meaning the control is not behaving as it should. Which part is on circuit B depends on the make and model.
Can I keep driving with code P2260 active?
With caution: limp mode possible, have it checked soon
Common causes — P2260
Stuck or faulty secondary air relay or valve Control wire touching a power supply Corroded or damaged connector Pump or valve with an electrical fault Faulty engine computer (rare)
How do you fix code P2260?
Check the relay, wiring and connectors of the secondary air system. If the pump runs without stopping, have the car checked soon to avoid overheating.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P225F — NOx sensor bank 1 sensor 2: signal biased or stuck...
- Next code: P2261 — Turbo/supercharger bypass valve: mechanical fault
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3