P2268 — Water in fuel sensor: intermittent signal
| Meaning | The control unit is getting an unstable signal from the water-in-fuel sensor. It does not necessarily mean there is water in the tank, only that the signal comes and goes. The sensor is usually fitted in the diesel fuel filter. |
| Family | Powertrain (P) |
Typical symptoms
No other driving problems in most cases
Check engine light on at times
A dashboard warning message that only shows up now and then
Common causes
Chafed wiring or a poor contact
Faulty sensor in the fuel filter
Moisture getting into the connector
A real but small amount of water disturbing the reading
What to do
How to read code P2268
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2268 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (68) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2268 mean?
Water in fuel sensor: intermittent signal. The control unit is getting an unstable signal from the water-in-fuel sensor. It does not necessarily mean there is water in the tank, only that the signal comes and goes. The sensor is usually fitted in the diesel fuel filter.
Can I keep driving with code P2268 active?
With caution: limp mode possible, have it checked soon
Common causes — P2268
Corroded or loose sensor connector Chafed wiring or a poor contact Faulty sensor in the fuel filter Moisture getting into the connector A real but small amount of water disturbing the reading
How do you fix code P2268?
First check the sensor connector on the fuel filter and its wiring. If the light comes on often, drain the water from the filter, because you cannot tell by eye whether it is a false alarm. Don't leave it for long: water in the fuel system damages the pump and the injectors.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2267 — Water in fuel sensor: signal high
- Next code: P2269 — Water detected in the fuel
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3