Skip to content
Fault code dictionary (DTC)

P2276 — O2 sensor 3 stuck lean, bank 2

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe third O2 sensor on bank 2 stays fixed on a signal that indicates a lean mixture. This sensor exists only on some exhaust layouts, usually after a second catalytic converter. The control unit judges it stuck and the signal no longer varies.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Usually no obvious change in driving
Slightly off fuel consumption in some cases
Possible failure at the emissions inspection

Common causes

Aged or faulty O2 sensor
Damaged wiring or connector
Exhaust leak near the sensor
A truly lean mixture on that bank
Catalytic converter in poor condition
Contaminated sensor

What to do

First check the wiring, the connector and any exhaust leaks near the bank 2 sensor. If all is well, the mixture needs to be checked. It won't stop the car, but it shouldn't be left for too long.

How to read code P2276

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2276 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (76) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2276 mean?

O2 sensor 3 stuck lean, bank 2. The third O2 sensor on bank 2 stays fixed on a signal that indicates a lean mixture. This sensor exists only on some exhaust layouts, usually after a second catalytic converter. The control unit judges it stuck and the signal no longer varies.

Can I keep driving with code P2276 active?

With caution: limp mode possible, have it checked soon

Common causes — P2276

Aged or faulty O2 sensor Damaged wiring or connector Exhaust leak near the sensor A truly lean mixture on that bank Catalytic converter in poor condition Contaminated sensor

How do you fix code P2276?

First check the wiring, the connector and any exhaust leaks near the bank 2 sensor. If all is well, the mixture needs to be checked. It won't stop the car, but it shouldn't be left for too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes