P2287 — Injector control pressure sensor circuit intermittent
| Meaning | The signal from the injector control pressure sensor drops out or jumps at times. This usually points to a poor electrical contact. The code is typical of diesel engines with oil-pressure-actuated injectors; for other makes I don't have reliable information. |
| Family | Powertrain (P) |
Typical symptoms
Occasional loss of power
Sometimes hard starting
Occasional uneven running
Sudden stalling in rare cases
Common causes
Partly broken or chafed wire
Sensor starting to fail
Ground or supply with poor contact
Vibration opening a faulty contact
What to do
How to read code P2287
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2287 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (87) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2287 mean?
Injector control pressure sensor circuit intermittent. The signal from the injector control pressure sensor drops out or jumps at times. This usually points to a poor electrical contact. The code is typical of diesel engines with oil-pressure-actuated injectors; for other makes I don't have reliable information.
Can I keep driving with code P2287 active?
With caution: limp mode possible, have it checked soon
Common causes — P2287
Loose or corroded connector Partly broken or chafed wire Sensor starting to fail Ground or supply with poor contact Vibration opening a faulty contact
How do you fix code P2287?
Check the connector and wiring, moving them carefully to see if the problem appears. An intermittent fault can leave you stranded, so don't put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2286 — Injector control pressure sensor circuit high
- Next code: P2288 — Injector control pressure too high
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3