Skip to content
Fault code dictionary (DTC)

P228C — Fuel pressure regulator A exceeded control limits: pressure too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer tried to bring the fuel pressure to the required value using regulator A, but couldn't: the pressure stays too low even at the maximum correction. The engine gets less fuel than it needs.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Lack of power, especially under load
Hesitation or jerking when accelerating
Long starting
Possible stalling
Misfires

Common causes

Clogged fuel filter
Weak fuel pump
Faulty or leaking pressure regulator
Leaks in the fuel circuit
Blocked or pinched fuel lines
Very low fuel level or poor quality fuel

What to do

First check the fuel level and quality and the condition of the filter. Low pressure can make the engine run lean, so don't delay the check.

How to read code P228C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P228C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (8C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P228C mean?

Fuel pressure regulator A exceeded control limits: pressure too low. The engine computer tried to bring the fuel pressure to the required value using regulator A, but couldn't: the pressure stays too low even at the maximum correction. The engine gets less fuel than it needs.

Can I keep driving with code P228C active?

With caution: limp mode possible, have it checked soon

Common causes — P228C

Clogged fuel filter Weak fuel pump Faulty or leaking pressure regulator Leaks in the fuel circuit Blocked or pinched fuel lines Very low fuel level or poor quality fuel

How do you fix code P228C?

First check the fuel level and quality and the condition of the filter. Low pressure can make the engine run lean, so don't delay the check.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes