P2291 — Injector control pressure too low during cranking
| Meaning | The control unit measured an injector control pressure that was too low while the engine was being turned over by the starter, before it started. This code mainly applies to diesels whose injection is driven by oil pressure (typical of some Ford diesels). On other makes the exact meaning may differ, so it should be checked against the manufacturer's data. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting, especially when cold
Engine does not start at all
Check engine light on
White or grey smoke at start-up
Common causes
Leaks in the high-pressure oil circuit or its fittings
Faulty injector control pressure sensor
Faulty pressure regulator
Worn high-pressure oil pump
Weak battery causing slow cranking
What to do
How to read code P2291
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2291 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (91) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2291 mean?
Injector control pressure too low during cranking. The control unit measured an injector control pressure that was too low while the engine was being turned over by the starter, before it started. This code mainly applies to diesels whose injection is driven by oil pressure (typical of some Ford diesels). On other makes the exact meaning may differ, so it should be checked against the manufacturer's data.
Can I keep driving with code P2291 active?
With caution: limp mode possible, have it checked soon
Common causes — P2291
Engine oil level or quality not suitable Leaks in the high-pressure oil circuit or its fittings Faulty injector control pressure sensor Faulty pressure regulator Worn high-pressure oil pump Weak battery causing slow cranking
How do you fix code P2291?
First check the oil level and condition, then the battery charge. If the car starts with difficulty, have it checked soon: repeated cranking wears the battery and the starter motor.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2290 — Injector control pressure too low
- Next code: P2292 — Injector control pressure erratic
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3