Skip to content
Fault code dictionary (DTC)

P229E — NOx sensor circuit fault, bank 1 sensor 2

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a fault in the NOx sensor circuit. This sensor measures nitrogen oxides in the exhaust gas after treatment. It is used to monitor the emission control system, often together with the AdBlue system on diesels. The exact meaning of 'sensor 2' depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Emission system fault warning
Possible power limitation
AdBlue-related message
Failed emissions test

Common causes

Faulty or worn-out NOx sensor
Damaged sensor connector or wiring
Faulty sensor control module
Moisture in the connector
Problem in the exhaust or AdBlue system

What to do

Check the sensor connector and wiring for moisture or damaged wires. Don't ignore the warning light: on many vehicles the system can limit performance if the fault stays.

How to read code P229E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P229E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (9E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P229E mean?

NOx sensor circuit fault, bank 1 sensor 2. The control unit detected a fault in the NOx sensor circuit. This sensor measures nitrogen oxides in the exhaust gas after treatment. It is used to monitor the emission control system, often together with the AdBlue system on diesels. The exact meaning of 'sensor 2' depends on the manufacturer.

Can I keep driving with code P229E active?

With caution: limp mode possible, have it checked soon

Common causes — P229E

Faulty or worn-out NOx sensor Damaged sensor connector or wiring Faulty sensor control module Moisture in the connector Problem in the exhaust or AdBlue system

How do you fix code P229E?

Check the sensor connector and wiring for moisture or damaged wires. Don't ignore the warning light: on many vehicles the system can limit performance if the fault stays.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes