P22A5 — NOx sensor heater control circuit high, bank 1 sensor 2
| Meaning | The control unit measured a voltage that is too high in the NOx sensor heater circuit. This usually points to a wire touching a power supply, or a fault in the heater control. The exact meaning of 'sensor 2' depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Emission system fault warning
Possible power limitation
AdBlue-related message
Failed emissions test
Common causes
Damaged wiring or insulation
Faulty NOx sensor heater
Faulty sensor control module
Faulty engine control unit (rare)
What to do
How to read code P22A5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22A5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (A5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22A5 mean?
NOx sensor heater control circuit high, bank 1 sensor 2. The control unit measured a voltage that is too high in the NOx sensor heater circuit. This usually points to a wire touching a power supply, or a fault in the heater control. The exact meaning of 'sensor 2' depends on the manufacturer.
Can I keep driving with code P22A5 active?
With caution: limp mode possible, have it checked soon
Common causes — P22A5
Heater wire touching a power supply Damaged wiring or insulation Faulty NOx sensor heater Faulty sensor control module Faulty engine control unit (rare)
How do you fix code P22A5?
Check the wiring and insulation near the sensor, especially where wires run close to the hot exhaust. Have it checked soon: a short to supply can damage other components.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22A4 — NOx sensor heater control circuit low, bank 1 sens...
- Next code: P22A6 — Downstream NOx sensor heater sense circuit fault
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3