P22AB — Downstream O2 sensor positive current control circuit open
| Meaning | The control unit cannot find continuity on the positive current control circuit of the oxygen sensor after the catalytic converter (bank 1, sensor 2). This circuit is part of the way a wideband sensor measures oxygen. An open circuit means the signal is not getting through somewhere along its path. |
| Family | Powertrain (P) |
Typical symptoms
Mixture control not optimal
Reduced catalyst monitoring ability
Other sensor codes may be stored
Sometimes no noticeable symptoms
Common causes
Broken wire in the harness
Internally damaged sensor
Poor terminal contact at the control unit
Heat or water damage to the wiring
What to do
How to read code P22AB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (AB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22AB mean?
Downstream O2 sensor positive current control circuit open. The control unit cannot find continuity on the positive current control circuit of the oxygen sensor after the catalytic converter (bank 1, sensor 2). This circuit is part of the way a wideband sensor measures oxygen. An open circuit means the signal is not getting through somewhere along its path.
Can I keep driving with code P22AB active?
With caution: limp mode possible, have it checked soon
Common causes — P22AB
Sensor connector unplugged or corroded Broken wire in the harness Internally damaged sensor Poor terminal contact at the control unit Heat or water damage to the wiring
How do you fix code P22AB?
Check the connector and wires of the downstream sensor. If everything looks fine, an electrical test of the circuit is needed. It is not an emergency, but do not leave it too long because the catalyst is not being monitored properly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22AA — Downstream NOx sensor heater sense circuit intermi...
- Next code: P22AC — Downstream O2 sensor positive current control circ...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3