Skip to content
Fault code dictionary (DTC)

P22B4 — Downstream O2 sensor negative current control circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detects a signal that is too high on the negative current control circuit of the downstream sensor (bank 1, sensor 2). It can be a short to a power wire, an open circuit or a faulty sensor.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Downstream oxygen reading not valid
Reduced catalyst monitoring
Other sensor codes
Possibly no symptoms

Common causes

Wiring touching a power wire
Connector with poor contact
Damaged sensor
Irregular supply
Internal control unit fault, rare

What to do

Check the connector, wires and supply of the sensor. If you see nothing, an electrical measurement is needed. Do not leave it too long.

How to read code P22B4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P22B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (B4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P22B4 mean?

Downstream O2 sensor negative current control circuit high. The control unit detects a signal that is too high on the negative current control circuit of the downstream sensor (bank 1, sensor 2). It can be a short to a power wire, an open circuit or a faulty sensor.

Can I keep driving with code P22B4 active?

With caution: limp mode possible, have it checked soon

Common causes — P22B4

Wiring touching a power wire Connector with poor contact Damaged sensor Irregular supply Internal control unit fault, rare

How do you fix code P22B4?

Check the connector, wires and supply of the sensor. If you see nothing, an electrical measurement is needed. Do not leave it too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes