P22B8 — Bank 2 downstream O2 sensor positive current control circuit open
| Meaning | The control unit cannot find continuity on the positive current control circuit of the oxygen sensor after the catalytic converter on bank 2 (sensor 2). Bank 2 is the other cylinder bank of the engine, found on V or flat engines. An open circuit means the signal is not getting through somewhere along its path. |
| Family | Powertrain (P) |
Typical symptoms
Bank 2 oxygen reading not valid
Bank 2 catalyst monitor not run
Related sensor codes may be stored
Often no obvious symptoms
Common causes
Broken wire in the harness
Damaged sensor
Poor contact at the control unit
Wiring damaged by heat or water
What to do
How to read code P22B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22B8 mean?
Bank 2 downstream O2 sensor positive current control circuit open. The control unit cannot find continuity on the positive current control circuit of the oxygen sensor after the catalytic converter on bank 2 (sensor 2). Bank 2 is the other cylinder bank of the engine, found on V or flat engines. An open circuit means the signal is not getting through somewhere along its path.
Can I keep driving with code P22B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P22B8
Sensor connector unplugged or corroded Broken wire in the harness Damaged sensor Poor contact at the control unit Wiring damaged by heat or water
How do you fix code P22B8?
Check the connector and wires of the bank 2 downstream sensor, taking care not to mix it up with the bank 1 one. Then an electrical test of the circuit is needed. It is not an emergency, but do not leave it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22B7 — Downstream O2 sensor pumping current trim circuit...
- Next code: P22B9 — Bank 2 downstream O2 sensor positive current contr...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3