P22D9 — Cylinder 1 alternative fuel injector control circuit open
| Meaning | The engine computer detected an open circuit in the control of the alternative fuel injector (for example gas) on cylinder 1. The electrical connection is broken and the injector does not receive its command. On a multi-fuel car, cylinder 1 may therefore run poorly on that fuel. |
| Family | Powertrain (P) |
Typical symptoms
Rough running on the alternative fuel
Lack of power
Forced switch to the main fuel
Hesitation or jerking when accelerating
Higher fuel consumption
Common causes
Broken wire in the harness
Injector coil open
Fault in the gas system computer or engine computer
Faulty ground or supply
What to do
How to read code P22D9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P22D9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (D9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P22D9 mean?
Cylinder 1 alternative fuel injector control circuit open. The engine computer detected an open circuit in the control of the alternative fuel injector (for example gas) on cylinder 1. The electrical connection is broken and the injector does not receive its command. On a multi-fuel car, cylinder 1 may therefore run poorly on that fuel.
Can I keep driving with code P22D9 active?
With caution: limp mode possible, have it checked soon
Common causes — P22D9
Injector connector loose or corroded Broken wire in the harness Injector coil open Fault in the gas system computer or engine computer Faulty ground or supply
How do you fix code P22D9?
Have the cylinder 1 injector connector and wiring checked first, then the injector resistance. If you smell gas, stop and have the system checked before going on.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P22D8 — Turbine inlet valve position sensor circuit interm...
- Next code: P22DA — Cylinder 1 alternative fuel injector control circu...
Related codes
- P2200 — NOx sensor circuit fault, bank 1
- P2201 — NOx sensor circuit range/performance, bank 1
- P2202 — NOx sensor circuit low input, bank 1
- P2203 — NOx sensor circuit high input, bank 1
- P2204 — NOx sensor intermittent signal, bank 1
- P2205 — NOx sensor heater control circuit open, bank 1
- P2206 — NOx sensor heater control circuit low, bank 1
- P2207 — NOx sensor heater control circuit high, bank 1
- P2208 — NOx sensor heater sense circuit, bank 1
- P2209 — NOx sensor heater sense circuit out of range, bank 1
- P220A — Speed signal comparison implausible, Y3/6n2 and Y3/6n3
- P220B — Speed too high, Y3/6n2 or Y3/6n3