Skip to content
Fault code dictionary (DTC)

P22EA — Cylinder 5 alternative fuel injector: control signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a lower voltage than expected on the control circuit of the cylinder 5 alternative fuel injector (for example the gas injector on a bi-fuel system). This usually means a wire is shorting to ground through damaged insulation, or the injector or its driver inside the control unit is drawing current abnormally. Often the problem is the wiring, not the injector.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough or jerky running on the alternative fuel
Loss of power
The car stays on or switches back to the normal fuel
Smell of unburnt fuel from the exhaust

Common causes

Control wire with damaged insulation touching ground
Dirty, wet or corroded injector connector
Injector with a shorted internal winding
Wiring pinched or rubbed near hot or moving parts
Faulty driver stage in the control unit (rare)

What to do

First check the connector and wiring of the cylinder 5 injector, looking for chafed wires, moisture and blackened terminals. Then the injector resistance and the wire's insulation to ground should be tested. You can use the normal fuel, but have it checked soon.

How to read code P22EA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P22EA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (2) points to fuel and air metering (injector circuit), and the last two (EA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P22EA mean?

Cylinder 5 alternative fuel injector: control signal too low. The control unit measured a lower voltage than expected on the control circuit of the cylinder 5 alternative fuel injector (for example the gas injector on a bi-fuel system). This usually means a wire is shorting to ground through damaged insulation, or the injector or its driver inside the control unit is drawing current abnormally. Often the problem is the wiring, not the injector.

Can I keep driving with code P22EA active?

With caution: limp mode possible, have it checked soon

Common causes — P22EA

Control wire with damaged insulation touching ground Dirty, wet or corroded injector connector Injector with a shorted internal winding Wiring pinched or rubbed near hot or moving parts Faulty driver stage in the control unit (rare)

How do you fix code P22EA?

First check the connector and wiring of the cylinder 5 injector, looking for chafed wires, moisture and blackened terminals. Then the injector resistance and the wire's insulation to ground should be tested. You can use the normal fuel, but have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes