P2337 — Cylinder 2 knock above threshold
| Meaning | Using the knock sensor, the engine computer detected knocking in cylinder 2 above the acceptable limit. Knock is an abnormal combustion that puts heavy stress on pistons and valves. The computer usually retards the ignition timing to protect the engine, but the cause still needs to be found. Some manufacturers use the code with small differences, so it should be confirmed on the specific model. |
| Family | Powertrain (P) |
Typical symptoms
Metallic rattling under acceleration or load
Loss of power
Rising fuel consumption
Engine temperature higher than usual
Sluggish pedal response
Common causes
Carbon deposits in the combustion chamber
Wrong or worn spark plugs
Faulty knock sensor or damaged wiring
Mixture too lean, for example from an air leak or dirty injector
Insufficient cooling
What to do
How to read code P2337
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2337 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (37) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2337 mean?
Cylinder 2 knock above threshold. Using the knock sensor, the engine computer detected knocking in cylinder 2 above the acceptable limit. Knock is an abnormal combustion that puts heavy stress on pistons and valves. The computer usually retards the ignition timing to protect the engine, but the cause still needs to be found. Some manufacturers use the code with small differences, so it should be confirmed on the specific model.
Can I keep driving with code P2337 active?
With caution: limp mode possible, have it checked soon
Common causes — P2337
Poor quality fuel or insufficient octane Carbon deposits in the combustion chamber Wrong or worn spark plugs Faulty knock sensor or damaged wiring Mixture too lean, for example from an air leak or dirty injector Insufficient cooling
How do you fix code P2337?
First check the fuel and the spark plugs, then the knock sensor and its connector. If the metallic knock is clearly audible, avoid hard acceleration and heavy loads, because prolonged knocking can damage the engine. Don't put the check off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2336 — Cylinder 1 knock above threshold
- Next code: P2338 — Cylinder 3 knock above threshold
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit