Skip to content
Fault code dictionary (DTC)

P233D — Fuel pressure regulator B solenoid supply open circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected an open circuit in the voltage supply to the solenoid of fuel pressure regulator "B". Without this supply the solenoid cannot work properly, and fuel pressure may not be regulated as needed. Which part is regulator "B" depends on the manufacturer, and I can't say without knowing make and model.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Hard or impossible starting
Loss of power
Rough idle
Sudden stalling
Reduced power in limp mode

Common causes

Faulty fuse or supply relay
Broken supply wire
Connector unplugged, corroded or damaged
Faulty regulator solenoid
Fault in the engine computer's supply circuit (rare)

What to do

First check the fuses, relays and the regulator connector, then the continuity of the supply wire. If the car stalls or loses a lot of power, avoid using it until it has been checked. Don't put it off.

How to read code P233D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P233D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (3D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P233D mean?

Fuel pressure regulator B solenoid supply open circuit. The engine computer detected an open circuit in the voltage supply to the solenoid of fuel pressure regulator "B". Without this supply the solenoid cannot work properly, and fuel pressure may not be regulated as needed. Which part is regulator "B" depends on the manufacturer, and I can't say without knowing make and model.

Can I keep driving with code P233D active?

With caution: limp mode possible, have it checked soon

Common causes — P233D

Faulty fuse or supply relay Broken supply wire Connector unplugged, corroded or damaged Faulty regulator solenoid Fault in the engine computer's supply circuit (rare)

How do you fix code P233D?

First check the fuses, relays and the regulator connector, then the continuity of the supply wire. If the car stalls or loses a lot of power, avoid using it until it has been checked. Don't put it off.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes