P2347 — Cylinder 12 knock level above threshold
| Meaning | The engine computer detected, through the knock sensor, vibrations in cylinder 12 above the limit it considers acceptable. This means combustion in that cylinder may be happening abnormally (pinging or pre-ignition). Cylinder numbering depends on the manufacturer, so cylinder 12 must be identified from the layout of your specific engine. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or sluggish throttle response
Check engine light on
Rough running under load
Fuel consumption that seems higher than usual
Common causes
Carbon deposits in the combustion chamber
Spark plug in cylinder 12 worn, wrong type or wrong heat range
Lean mixture or a poorly delivering injector on that cylinder
Faulty knock sensor or wiring giving a false signal
Local overheating or a mechanical problem in the cylinder
What to do
How to read code P2347
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2347 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (47) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2347 mean?
Cylinder 12 knock level above threshold. The engine computer detected, through the knock sensor, vibrations in cylinder 12 above the limit it considers acceptable. This means combustion in that cylinder may be happening abnormally (pinging or pre-ignition). Cylinder numbering depends on the manufacturer, so cylinder 12 must be identified from the layout of your specific engine.
Can I keep driving with code P2347 active?
With caution: limp mode possible, have it checked soon
Common causes — P2347
Fuel of poor quality or lower octane than required Carbon deposits in the combustion chamber Spark plug in cylinder 12 worn, wrong type or wrong heat range Lean mixture or a poorly delivering injector on that cylinder Faulty knock sensor or wiring giving a false signal Local overheating or a mechanical problem in the cylinder
How do you fix code P2347?
First check the fuel you used and the condition of the spark plug and coil on cylinder 12. Avoid heavy loads and hard acceleration until it is checked, because prolonged knock can damage pistons and gaskets. Have the code read with a tool that shows live data before putting the engine under strain again.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2346 — Cylinder 11 knock level above threshold
- Next code: P2348 — Cylinder 9 pressure sensor circuit fault
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit