Skip to content
Fault code dictionary (DTC)

P2367 — Cylinder 12: pressure sensor signal out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit is receiving a signal from the cylinder 12 pressure sensor that does not match what it expects, without being a clear electrical fault. It can mean an aged or dirty sensor, or a genuinely abnormal reading in the cylinder. The code is standard and applies to engines with 12 or more cylinders.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Occasionally uneven running
Slight drop in performance
Combustion managed less accurately
Fuel consumption a little off
Often no obvious symptoms

Common causes

Dirty, worn or drifting cylinder pressure sensor
Connector or wiring with abnormal resistance
Carbon deposits affecting the sensor
A real combustion problem in cylinder 12
Software or control unit fault, which is rare

What to do

Have the wiring and connector checked, then compare the signal with the other cylinders to see whether the sensor or the cylinder is out of norm. It is not an immediate emergency, but do not put it off for long.

How to read code P2367

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2367 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (67) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2367 mean?

Cylinder 12: pressure sensor signal out of range. The control unit is receiving a signal from the cylinder 12 pressure sensor that does not match what it expects, without being a clear electrical fault. It can mean an aged or dirty sensor, or a genuinely abnormal reading in the cylinder. The code is standard and applies to engines with 12 or more cylinders.

Can I keep driving with code P2367 active?

With caution: limp mode possible, have it checked soon

Common causes — P2367

Dirty, worn or drifting cylinder pressure sensor Connector or wiring with abnormal resistance Carbon deposits affecting the sensor A real combustion problem in cylinder 12 Software or control unit fault, which is rare

How do you fix code P2367?

Have the wiring and connector checked, then compare the signal with the other cylinders to see whether the sensor or the cylinder is out of norm. It is not an immediate emergency, but do not put it off for long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes