P236B — Cylinder 12: cylinder pressure too low
| Meaning | The control unit detects that the pressure in cylinder 12 is lower than expected. It can come from a real loss of compression or from a sensor reading incorrectly. The code is standard and applies to engines with 12 or more cylinders. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Check engine light on
Harder starting
Smoke from the exhaust in some cases
Higher fuel consumption
Common causes
Worn piston rings or cylinder
Failing cylinder head gasket
Injector or ignition on cylinder 12 not working well
Drifting cylinder pressure sensor
Valve timing problem
What to do
How to read code P236B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P236B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (6B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P236B mean?
Cylinder 12: cylinder pressure too low. The control unit detects that the pressure in cylinder 12 is lower than expected. It can come from a real loss of compression or from a sensor reading incorrectly. The code is standard and applies to engines with 12 or more cylinders.
Can I keep driving with code P236B active?
With caution: limp mode possible, have it checked soon
Common causes — P236B
Compression loss from a worn valve or seat Worn piston rings or cylinder Failing cylinder head gasket Injector or ignition on cylinder 12 not working well Drifting cylinder pressure sensor Valve timing problem
How do you fix code P236B?
Have the compression of cylinder 12 measured and compared with the others, so it is clear whether the fault is real or in the sensor. If it is real, do not push the engine: it can get worse and cause serious damage.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P236A — Cylinder 12: pressure sensor signal intermittent
- Next code: P236C — Cylinder 12: cylinder pressure too high
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit