P239E — O2 sensor out of range during deceleration, bank 1 sensor 2
| Meaning | During deceleration, when only air flows through the exhaust, the sensor after the catalytic converter on bank 1 gave a value outside the expected range. The computer uses this phase to check that the sensor responds correctly. |
| Family | Powertrain (P) |
Typical symptoms
Slightly irregular fuel use
Unstable idle in some cases
No obvious symptoms
Possible emissions test failure
Common causes
Damaged sensor wiring or connector
Exhaust leak near the sensor
Sensor contaminated by oil or additives
Catalytic converter in poor condition
Faulty sensor heater
What to do
How to read code P239E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P239E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (9E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P239E mean?
O2 sensor out of range during deceleration, bank 1 sensor 2. During deceleration, when only air flows through the exhaust, the sensor after the catalytic converter on bank 1 gave a value outside the expected range. The computer uses this phase to check that the sensor responds correctly.
Can I keep driving with code P239E active?
With caution: limp mode possible, have it checked soon
Common causes — P239E
Aged or slow downstream sensor Damaged sensor wiring or connector Exhaust leak near the sensor Sensor contaminated by oil or additives Catalytic converter in poor condition Faulty sensor heater
How do you fix code P239E?
First check the wiring, the connector and exhaust sealing around the sensor. The car is usually drivable, but have it checked soon to avoid stressing the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P239D — Diesel intake air flow B control system: low air f...
- Next code: P239F — O2 sensor out of range during deceleration, bank 2...
Related codes
- P2300 — Ignition coil A primary control circuit low
- P2301 — Ignition coil A primary control circuit high
- P2302 — Ignition coil A secondary circuit
- P2303 — Ignition coil B primary control circuit low
- P2304 — Ignition coil B primary control circuit high
- P2305 — Ignition coil B secondary circuit
- P2306 — Ignition coil C primary control circuit low
- P2307 — Ignition coil C primary control circuit high
- P2308 — Ignition coil C secondary circuit
- P2309 — Ignition coil D primary control circuit low
- P230A — Cylinder 1 air-fuel imbalance, adjustment at limit
- P230B — Cylinder 2 air-fuel imbalance, adjustment at limit