P2407 — EVAP leak detection pump sense circuit intermittent
| Meaning | The control unit reads the feedback signal of the leak detection pump during the fuel vapor tightness test. It detected that this signal comes and goes or is unstable, as happens with an electrical contact that works only at times. The fault comes and goes and can be harder to find. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Vapor system test that sometimes does not complete
Possible failure of the emissions inspection
Common causes
Signal wire partly broken or chafed
Leak detection pump working only at times
Moisture in the connector
Wiring that vibrates or touches vehicle parts
Control unit fault (rare)
What to do
How to read code P2407
This is an informational entry: it normally does not limit how the vehicle works.
The code P2407 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (07) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2407 mean?
EVAP leak detection pump sense circuit intermittent. The control unit reads the feedback signal of the leak detection pump during the fuel vapor tightness test. It detected that this signal comes and goes or is unstable, as happens with an electrical contact that works only at times. The fault comes and goes and can be harder to find.
Can I keep driving with code P2407 active?
With caution: limp mode possible, have it checked soon
Common causes — P2407
Pump connector with weak or corroded contact Signal wire partly broken or chafed Leak detection pump working only at times Moisture in the connector Wiring that vibrates or touches vehicle parts Control unit fault (rare)
How do you fix code P2407?
Check the pump connector and wiring, gently moving them to see whether the signal changes. It is not a safety urgency, but an uncertain contact tends to get worse over time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2406 — EVAP leak detection pump sense circuit high
- Next code: P2408 — Fuel cap sensor/switch circuit
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible
- P240C — Gear selector lever position via CAN implausible