P2512 — Event data recorder request circuit open
| Meaning | This code concerns the circuit through which the event data recorder, usually tied to the airbag system, requests information from the engine control unit. The control unit found the circuit open or broken. How exactly this circuit is used depends on the manufacturer, so I cannot give the detail for every make. |
| Family | Powertrain (P) |
Typical symptoms
Possibly the airbag light on, depending on the vehicle
Usually no change in how the car drives
Other communication codes between control units
Scan tool showing the fault in memory
Common causes
Connector unplugged, corroded or with bent pins
Fault in the module that records the events
Wiring damaged after an impact or a repair
Engine control unit problem (rare)
What to do
How to read code P2512
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2512 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (12) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2512 mean?
Event data recorder request circuit open. This code concerns the circuit through which the event data recorder, usually tied to the airbag system, requests information from the engine control unit. The control unit found the circuit open or broken. How exactly this circuit is used depends on the manufacturer, so I cannot give the detail for every make.
Can I keep driving with code P2512 active?
With caution: limp mode possible, have it checked soon
Common causes — P2512
Broken wire in the circuit Connector unplugged, corroded or with bent pins Fault in the module that records the events Wiring damaged after an impact or a repair Engine control unit problem (rare)
How do you fix code P2512?
Have the codes read from all control units, including the airbag one, and the wiring and connectors of the circuit inspected. If the airbag light is on, get it checked soon, because passive safety may be affected.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2511 — Control unit power relay sense circuit intermitten...
- Next code: P2513 — Event data recorder request circuit low
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault