P2520 — A/C request "A" circuit low
| Meaning | The engine control unit read a lower than normal voltage in the circuit the climate system uses to ask for the compressor to switch on (request "A"). It usually indicates a wire touching ground or a broken contact. |
| Family | Powertrain (P) |
Typical symptoms
The compressor does not start
Check engine light on
The fans do not react to the A/C request
Common causes
Corroded or loose connector
Faulty A/C switch or control
Climate control unit not sending the signal
Engine control unit fault, which is rare
What to do
How to read code P2520
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2520 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (20) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2520 mean?
A/C request "A" circuit low. The engine control unit read a lower than normal voltage in the circuit the climate system uses to ask for the compressor to switch on (request "A"). It usually indicates a wire touching ground or a broken contact.
Can I keep driving with code P2520 active?
With caution: limp mode possible, have it checked soon
Common causes — P2520
Signal wire touching ground Corroded or loose connector Faulty A/C switch or control Climate control unit not sending the signal Engine control unit fault, which is rare
How do you fix code P2520?
First check the wires and connectors of the request circuit, looking for chafed spots or contact with the bodywork. It is not a safety issue, but the A/C may stay out of service.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P251F — PTO engine shutdown circuit high
- Next code: P2521 — A/C request "A" circuit high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault