Skip to content
Fault code dictionary (DTC)

P2527 — Vacuum reservoir pressure sensor circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit read a lower than normal voltage from the vacuum reservoir sensor. It usually indicates a wire touching ground, a missing supply, or a faulty sensor. The vacuum is used, among other things, by the brake booster.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Brake pedal harder than usual
Vacuum-operated actuators responding poorly
Engine running less smoothly

Common causes

Signal wire touching ground
Interrupted sensor supply
Faulty sensor
Corroded or loose connector
Control unit fault, which is rare

What to do

Check the sensor connector and wiring, then the condition of the vacuum hoses. If the brake pedal is unusually hard, have the car checked without waiting.

How to read code P2527

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P2527 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (27) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P2527 mean?

Vacuum reservoir pressure sensor circuit low. The control unit read a lower than normal voltage from the vacuum reservoir sensor. It usually indicates a wire touching ground, a missing supply, or a faulty sensor. The vacuum is used, among other things, by the brake booster.

Can I keep driving with code P2527 active?

With caution: limp mode possible, have it checked soon

Common causes — P2527

Signal wire touching ground Interrupted sensor supply Faulty sensor Corroded or loose connector Control unit fault, which is rare

How do you fix code P2527?

Check the sensor connector and wiring, then the condition of the vacuum hoses. If the brake pedal is unusually hard, have the car checked without waiting.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes