Skip to content
Fault code dictionary (DTC)

P253C — PTO sense circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe power take-off (PTO) sensor signal reaches the control unit at too low a voltage. There is usually a short to ground or a contact with too much resistance. The control unit may not know whether the PTO is engaged.
FamilyPowertrain (P)

Typical symptoms

PTO not recognised or engaging irregularly
Engine speed not consistent with PTO use
Fault light on
Equipment not working well

Common causes

Sensor wire shorted to ground
Corroded connector or water inside
Faulty PTO sensor
Faulty sensor supply or ground
Control unit problem, rare

What to do

Check the sensor wiring along its whole run for crushed or worn wires, and the connector. If the vehicle has no PTO, have the configuration checked.

How to read code P253C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P253C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (3C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P253C mean?

PTO sense circuit low. The power take-off (PTO) sensor signal reaches the control unit at too low a voltage. There is usually a short to ground or a contact with too much resistance. The control unit may not know whether the PTO is engaged.

Can I keep driving with code P253C active?

With caution: limp mode possible, have it checked soon

Common causes — P253C

Sensor wire shorted to ground Corroded connector or water inside Faulty PTO sensor Faulty sensor supply or ground Control unit problem, rare

How do you fix code P253C?

Check the sensor wiring along its whole run for crushed or worn wires, and the connector. If the vehicle has no PTO, have the configuration checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes