P255A — PTO speed selector 2: open circuit
| Meaning | The control unit detected an open circuit in the second sensor or switch used to choose the speed of the power take-off (PTO), the output that drives equipment such as pumps or cranes. It mainly concerns commercial and industrial vehicles. I don't have reliable details on exactly how it works for every make. |
| Family | Powertrain (P) |
Typical symptoms
PTO speed cannot be selected
Check engine light on
Connected equipment stopped or unstable
Engine normal when PTO is not in use
Common causes
Unplugged or corroded connector
Faulty selector or switch
Wiring damaged by vibration
Control unit failure (rare)
What to do
How to read code P255A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P255A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (5A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P255A mean?
PTO speed selector 2: open circuit. The control unit detected an open circuit in the second sensor or switch used to choose the speed of the power take-off (PTO), the output that drives equipment such as pumps or cranes. It mainly concerns commercial and industrial vehicles. I don't have reliable details on exactly how it works for every make.
Can I keep driving with code P255A active?
With caution: limp mode possible, have it checked soon
Common causes — P255A
Broken wire in the selector circuit Unplugged or corroded connector Faulty selector or switch Wiring damaged by vibration Control unit failure (rare)
How do you fix code P255A?
First check the selector's connectors and wiring, especially where vibration is present. Until it's fixed, avoid using the connected equipment.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2559 — Coolant level sensor circuit: signal too high
- Next code: P255B — PTO speed selector 2: implausible signal
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault