P2566 — Turbo boost control position sensor: intermittent signal
| Meaning | The turbo boost control position sensor signal comes and goes. It is usually a contact lost to vibration, heat or moisture, but it can also be a sensor that is starting to fail. |
| Family | Powertrain (P) |
Typical symptoms
Sudden power losses
Turbo boosting irregularly
Protection mode that appears and disappears
Problem that depends on vibration
Common causes
Partially broken or chafed wire
Sensor starting to fail
Excessive heat near the turbo
Moisture in the circuit
What to do
How to read code P2566
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2566 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (66) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2566 mean?
Turbo boost control position sensor: intermittent signal. The turbo boost control position sensor signal comes and goes. It is usually a contact lost to vibration, heat or moisture, but it can also be a sensor that is starting to fail.
Can I keep driving with code P2566 active?
With caution: limp mode possible, have it checked soon
Common causes — P2566
Loose or corroded connector Partially broken or chafed wire Sensor starting to fail Excessive heat near the turbo Moisture in the circuit
How do you fix code P2566?
Have connectors and wiring checked, especially near the turbo where heat damages wires. The problem may get worse, so don't put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2565 — Turbo boost control position sensor: signal too hi...
- Next code: P2567 — Ozone reduction catalyst temperature sensor circui...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault