P256A — Idle speed selector circuit open
| Meaning | The control unit no longer detects the signal from the selector used to choose the idle speed, which is fitted only on some vehicles, for example those with a power take-off or special bodywork. The circuit appears broken or open. The exact meaning depends on the manufacturer and equipment, so I cannot say for certain which control is involved on your vehicle. |
| Family | Powertrain (P) |
Typical symptoms
Idle speed not responding to the selector
Idle fixed or different from usual
Idle control on the dashboard does nothing
Common causes
Broken wire in the selector wiring
Faulty selector or switch
Missing power or ground at the selector
Control unit problem (rare)
What to do
How to read code P256A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P256A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (6A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P256A mean?
Idle speed selector circuit open. The control unit no longer detects the signal from the selector used to choose the idle speed, which is fitted only on some vehicles, for example those with a power take-off or special bodywork. The circuit appears broken or open. The exact meaning depends on the manufacturer and equipment, so I cannot say for certain which control is involved on your vehicle.
Can I keep driving with code P256A active?
With caution: limp mode possible, have it checked soon
Common causes — P256A
Selector connector unplugged or corroded Broken wire in the selector wiring Faulty selector or switch Missing power or ground at the selector Control unit problem (rare)
How do you fix code P256A?
First check that the selector connector is fully seated and free of corrosion, then check the wires for continuity. It is usually not urgent, but have the circuit checked if the idle behaves strangely.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2569 — Ozone reduction catalyst temp sensor signal too lo...
- Next code: P256B — Idle speed selector signal out of range or implaus...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault