P256C — Idle speed selector circuit signal too low
| Meaning | The control unit measured a lower voltage than normal on the idle speed selector circuit, typical of a wire touching ground or a short circuit. The selector is fitted only on some vehicles and the exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Idle stuck at a fixed value
Selector not responding
Possible other codes on the same circuit
Common causes
Wet or damaged connector
Faulty or shorted selector
Wiring rubbed or pinched
Control unit problem (rare)
What to do
How to read code P256C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P256C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (6C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P256C mean?
Idle speed selector circuit signal too low. The control unit measured a lower voltage than normal on the idle speed selector circuit, typical of a wire touching ground or a short circuit. The selector is fitted only on some vehicles and the exact meaning depends on the manufacturer.
Can I keep driving with code P256C active?
With caution: limp mode possible, have it checked soon
Common causes — P256C
Selector wire touching ground Wet or damaged connector Faulty or shorted selector Wiring rubbed or pinched Control unit problem (rare)
How do you fix code P256C?
Check the selector wiring for damaged wires touching the body and make sure the connector is dry and intact. Have the circuit checked soon if the idle is not regular.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P256B — Idle speed selector signal out of range or implaus...
- Next code: P256D — Idle speed selector circuit signal too high
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault