P2590 — Turbo boost control position sensor B circuit intermittent/erratic
| Meaning | The control unit is getting a signal that comes and goes, or is unstable, from position sensor B of the turbo boost control. The fault is not always present, which points to a poor contact or a sensor that gives out with heat. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power from time to time
Turbo pushing unevenly
Limp mode now and then
Problem showing up with vibration or heat
Common causes
Wire partly broken or chafed
Position sensor failing when it heats up
Wiring vibrating against hot parts
Control unit fault (rare)
What to do
How to read code P2590
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2590 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (90) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2590 mean?
Turbo boost control position sensor B circuit intermittent/erratic. The control unit is getting a signal that comes and goes, or is unstable, from position sensor B of the turbo boost control. The fault is not always present, which points to a poor contact or a sensor that gives out with heat.
Can I keep driving with code P2590 active?
With caution: limp mode possible, have it checked soon
Common causes — P2590
Sensor connector loose or corroded Wire partly broken or chafed Position sensor failing when it heats up Wiring vibrating against hot parts Control unit fault (rare)
How do you fix code P2590?
With the engine off, carefully move the wiring and connector to look for the faulty spot. Do not ignore it: an intermittent fault tends to get worse and can limit power.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P258F — Torque management request output signal
- Next code: P2591 — Cruise control front distance sensor, left side
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault