P2597 — Turbo B speed sensor circuit: intermittent signal
| Meaning | The signal from the turbo B speed sensor comes and goes. The control unit loses it at times and then picks it up again. This is usually a poor contact, which shows up with vibration or when the engine is hot. |
| Family | Powertrain (P) |
Typical symptoms
Sudden, brief drops in power
Uneven behavior when accelerating
Problem appearing with a hot engine or on rough roads
Common causes
Wire partly broken inside its sheath
Wiring rubbing against engine parts
Turbo speed sensor with an intermittent fault
Grounds or supplies with a weak contact
What to do
How to read code P2597
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2597 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (97) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2597 mean?
Turbo B speed sensor circuit: intermittent signal. The signal from the turbo B speed sensor comes and goes. The control unit loses it at times and then picks it up again. This is usually a poor contact, which shows up with vibration or when the engine is hot.
Can I keep driving with code P2597 active?
With caution: limp mode possible, have it checked soon
Common causes — P2597
Loose or corroded sensor connector Wire partly broken inside its sheath Wiring rubbing against engine parts Turbo speed sensor with an intermittent fault Grounds or supplies with a weak contact
How do you fix code P2597?
Have the connector and wiring checked by wiggling them with the engine running to bring out the fault. It is not an immediate emergency, but an intermittent fault tends to get worse, so do not leave it for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2596 — Turbo B speed sensor circuit: signal too high
- Next code: P2598 — Turbo A boost control position sensor: stuck low
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault