P25A6 — Fuel mode selector switch: circuit voltage too low
| Meaning | The control unit reads a lower than normal voltage on the fuel mode switch circuit. This usually means a wire shorted to ground, an internal short, or a contact that will not open. The system cannot tell which mode you have selected. |
| Family | Powertrain (P) |
Typical symptoms
Fuel mode does not change when the switch is pressed
The car always starts on the same fuel
Mode indicator is off or stuck
Possible reduced operation of the dual-fuel system
Common causes
Faulty switch with an internal short
Wet or corroded connector
Pinched or chafed wiring
Internal control unit fault (rare)
What to do
How to read code P25A6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25A6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (A6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25A6 mean?
Fuel mode selector switch: circuit voltage too low. The control unit reads a lower than normal voltage on the fuel mode switch circuit. This usually means a wire shorted to ground, an internal short, or a contact that will not open. The system cannot tell which mode you have selected.
Can I keep driving with code P25A6 active?
With caution: limp mode possible, have it checked soon
Common causes — P25A6
Signal wire touching ground Faulty switch with an internal short Wet or corroded connector Pinched or chafed wiring Internal control unit fault (rare)
How do you fix code P25A6?
Inspect the switch wiring and connector for chafed wires or moisture. This is not an immediate safety problem, but it should be checked as soon as practical.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25A5 — Fuel mode selector switch: implausible signal
- Next code: P25A7 — Fuel mode selector switch: circuit voltage too hig...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault