P25AB — Piston cooling oil control: circuit voltage high
| Meaning | The control unit detected a higher than normal voltage on the circuit of the piston cooling oil valve. It may be a wire shorted to a power supply, or a circuit that does not close properly. The valve may not respond to commands. |
| Family | Powertrain (P) |
Typical symptoms
Possible oil pressure warning
Engine noise
Power limitation
Often no noticeable symptom
Common causes
Faulty valve
Damaged or corroded connector
Damaged wiring
Control driver fault in the control unit (rare)
What to do
How to read code P25AB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (AB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25AB mean?
Piston cooling oil control: circuit voltage high. The control unit detected a higher than normal voltage on the circuit of the piston cooling oil valve. It may be a wire shorted to a power supply, or a circuit that does not close properly. The valve may not respond to commands.
Can I keep driving with code P25AB active?
With caution: limp mode possible, have it checked soon
Common causes — P25AB
Control wire shorted to a power supply Faulty valve Damaged or corroded connector Damaged wiring Control driver fault in the control unit (rare)
How do you fix code P25AB?
Check the valve wiring and connector and the oil level. Avoid straining the engine until the circuit has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25AA — Piston cooling oil control: circuit voltage low
- Next code: P25AC — Piston cooling oil control: valve stuck off or not...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault