P25BD — Unmetered fuel: forced engine shutdown
| Meaning | The control unit detected fuel reaching the engine that the injection system was not controlling, and shut the engine down as a safety measure. The engine may rev up or run in an uncontrolled way. What exactly triggers it depends on the engine type and manufacturer, and I have no reliable information for a specific brand. |
| Family | Powertrain (P) |
Typical symptoms
Engine revving up without pressing the accelerator
Check engine light on
Unusual exhaust smoke
Trouble restarting right after the shutdown
Common causes
Engine oil diluted by fuel or another combustible source
Fault in a component that meters fuel
Intake system problem bringing in excess combustible
Software or control unit fault, less common
What to do
How to read code P25BD
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P25BD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (BD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25BD mean?
Unmetered fuel: forced engine shutdown. The control unit detected fuel reaching the engine that the injection system was not controlling, and shut the engine down as a safety measure. The engine may rev up or run in an uncontrolled way. What exactly triggers it depends on the engine type and manufacturer, and I have no reliable information for a specific brand.
Can I keep driving with code P25BD active?
With caution: limp mode possible, have it checked soon
Common causes — P25BD
Leaking or stuck-open injector Engine oil diluted by fuel or another combustible source Fault in a component that meters fuel Intake system problem bringing in excess combustible Software or control unit fault, less common
How do you fix code P25BD?
This is a serious fault: if the engine revs on its own or shuts off, stop using the car. Have the fuel system checked right away, along with the level and smell of the engine oil.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25BC — Regeneration switch: signal too high
- Next code: P25BE — Alternative fuel disable control: open circuit
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault