P25CB — Intake camshaft actuator park lock control: low (bank 1)
| Meaning | The control unit reads too low a voltage in the control circuit of the intake camshaft actuator park lock, bank 1. This usually means contact with ground or a shorted component. The exact operation depends on the manufacturer and I have no reliable information for a specific brand. |
| Family | Powertrain (P) |
Typical symptoms
Metallic rattle or knock at cold start
Rough idle
Loss of performance
Higher fuel use than usual
Common causes
Park lock solenoid internally shorted
Pinched wiring or damaged insulation
Connector with moisture
Control unit fault, less common
What to do
How to read code P25CB
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P25CB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (CB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P25CB mean?
Intake camshaft actuator park lock control: low (bank 1). The control unit reads too low a voltage in the control circuit of the intake camshaft actuator park lock, bank 1. This usually means contact with ground or a shorted component. The exact operation depends on the manufacturer and I have no reliable information for a specific brand.
Can I keep driving with code P25CB active?
With caution: limp mode possible, have it checked soon
Common causes — P25CB
Control wire touching ground Park lock solenoid internally shorted Pinched wiring or damaged insulation Connector with moisture Control unit fault, less common
How do you fix code P25CB?
First check the engine oil, wiring and control connector, looking for chafed or wet wires. If unusual engine noises appear, don't keep driving the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P25CA — Intake camshaft actuator park lock control: open c...
- Next code: P25CC — Intake camshaft actuator park lock control: high (...
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault