P2659 — Bank 2 rocker arm actuator control circuit high
| Meaning | The engine computer commands a rocker arm actuator (part of the valve timing or cylinder deactivation system) on bank 2 and read a voltage that is too high on the control circuit. Bank 2 is the side of the engine opposite cylinder 1. The exact function depends on the manufacturer's system, but the fault is electrical, in the actuator circuit. |
| Family | Powertrain (P) |
Typical symptoms
Engine feels weaker, especially under load
Rough or unstable idle
Unusual mechanical noise from the cylinder heads
Fuel consumption that seems higher than usual
Cylinder deactivation no longer working
Common causes
Corroded actuator connector or bent pins
Faulty actuator or control solenoid
Wrong oil level or oil type affecting the system
Faulty driver inside the engine computer (rare)
What to do
How to read code P2659
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2659 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (59) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2659 mean?
Bank 2 rocker arm actuator control circuit high. The engine computer commands a rocker arm actuator (part of the valve timing or cylinder deactivation system) on bank 2 and read a voltage that is too high on the control circuit. Bank 2 is the side of the engine opposite cylinder 1. The exact function depends on the manufacturer's system, but the fault is electrical, in the actuator circuit.
Can I keep driving with code P2659 active?
With caution: limp mode possible, have it checked soon
Common causes — P2659
Actuator wiring shorted to supply voltage Corroded actuator connector or bent pins Faulty actuator or control solenoid Wrong oil level or oil type affecting the system Faulty driver inside the engine computer (rare)
How do you fix code P2659?
Start by checking the connector and wiring of the bank 2 actuator, then test the actuator using the manufacturer's procedure. Check the oil level and type as well. The car can usually be driven, but don't leave it for long, since a valve system that isn't working properly can get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2658 — Rocker arm actuator A control circuit low, bank 2
- Next code: P265A — Bank 1 rocker arm actuator B position sensor circu...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low