P265C — Bank 1 rocker arm actuator B position sensor circuit low
| Meaning | The computer reads a voltage that is too low in the circuit of the position sensor for rocker arm actuator 'B' on bank 1. This usually points to a wire shorted to ground, a break, or a failed sensor. The exact system depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power in some conditions
Uneven idle
Valve system switched off by the computer
Less smooth running
Common causes
Broken wire or loose connector
Failed position sensor
Missing sensor supply voltage
Internal engine computer fault (rare)
What to do
How to read code P265C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P265C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (5C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P265C mean?
Bank 1 rocker arm actuator B position sensor circuit low. The computer reads a voltage that is too low in the circuit of the position sensor for rocker arm actuator 'B' on bank 1. This usually points to a wire shorted to ground, a break, or a failed sensor. The exact system depends on the manufacturer.
Can I keep driving with code P265C active?
With caution: limp mode possible, have it checked soon
Common causes — P265C
Sensor wiring shorted to ground Broken wire or loose connector Failed position sensor Missing sensor supply voltage Internal engine computer fault (rare)
How do you fix code P265C?
Start with the connector and wiring of the bank 1 sensor, then check the sensor's supply and ground. You can drive cautiously, but it is best to have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P265B — Bank 1 rocker arm actuator B position sensor range...
- Next code: P265D — Bank 1 rocker arm actuator B position sensor circu...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low