Skip to content
Fault code dictionary (DTC)

P265E — Bank 1 rocker arm actuator B position sensor intermittent

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe signal from the position sensor of rocker arm actuator 'B' on bank 1 drops out or jumps erratically. It is usually an electrical contact that breaks at times because of vibration, heat or moisture. Details depend on the manufacturer's system.
FamilyPowertrain (P)

Typical symptoms

Check engine light coming on and off
Intermittent loss of power
Idle that hunts
Problem appears when hot or on rough roads
Occasional jerking or hesitation

Common causes

Connector with loose or corroded contacts
Chafed wiring or damaged insulation
Sensor with an intermittent internal fault
Poor sensor ground connection
Moisture or oil in the connector

What to do

Gently move the sensor wiring and connector with the engine running to find the faulty contact, ideally in a workshop. An intermittent fault is harder to find, so don't erase the code: it is needed for the diagnosis.

How to read code P265E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P265E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (5E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P265E mean?

Bank 1 rocker arm actuator B position sensor intermittent. The signal from the position sensor of rocker arm actuator 'B' on bank 1 drops out or jumps erratically. It is usually an electrical contact that breaks at times because of vibration, heat or moisture. Details depend on the manufacturer's system.

Can I keep driving with code P265E active?

With caution: limp mode possible, have it checked soon

Common causes — P265E

Connector with loose or corroded contacts Chafed wiring or damaged insulation Sensor with an intermittent internal fault Poor sensor ground connection Moisture or oil in the connector

How do you fix code P265E?

Gently move the sensor wiring and connector with the engine running to find the faulty contact, ideally in a workshop. An intermittent fault is harder to find, so don't erase the code: it is needed for the diagnosis.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes